Microwave Vacuum Dryer 300 kg/batch

Combination dryer that removes water under vacuum with microwave energy, drying heat-sensitive fruit and vegetable pieces fast with less colour and flavour loss.

SKU: VL-056 Category: Tag:

Microwave Vacuum Dryer

Microwave vacuum dryer removing moisture at low temperature under vacuum

Dryer that applies microwave energy to product held under vacuum, so water is driven off at a low temperature and from the inside of the piece outward.

How it works

Product is loaded on trays or in a rotating drum inside a vacuum chamber. Microwave energy is generated by magnetrons and coupled into the chamber, where it is absorbed by water throughout the piece rather than only at the surface. Under vacuum, the boiling point of that water is low, so it vapourises at a temperature far below what hot air would require. The vapour is removed by the vacuum system and condensed.

Because the energy is deposited volumetrically and the boiling point is low, drying is both fast and cool — which is the combination hot-air drying cannot give.

Suitable for

High-value berries and soft fruit where colour and shape command a premium; heat-sensitive product where hot air browns or degrades flavour; thick pieces where hot-air drying gives a hard skin and a wet core; fruit pieces for cereal, confectionery and premium snack; finishing a product that a hot-air dryer has already taken most of the way.

Not suitable for

Product where capital cost per kg of water removed is decisive — this is an expensive way to remove water; very large or dense loads with poor microwave penetration; product with metal or foil in the pack, which must never enter the chamber; low-value commodity drying.

Material & compliance

Chamber, trays or drum and vapour path in SUS304 (EN 1.4301); chamber sealed for vacuum and microwave, with interlocks on all access points. Microwave leakage monitored and interlocked to the specified limit; door seals and viewing screens rated for the duty.

Supplied with CE declaration of conformity and DoC on request; material certificate EN 10204 3.1 available for contact parts. Microwave equipment carries its own safety documentation and leakage certification.

Selection notes

Ask for a cycle on your own product to your target moisture — microwave drying does not scale linearly, and the last part of the moisture is where most machines struggle. Check penetration depth for your piece size; thick product dries unevenly if the energy cannot reach the centre. Confirm the microwave safety arrangements, since leakage limits and interlocks are the part of the specification you cannot negotiate on.

When you should not buy this machine: If you are drying a commodity vegetable on price, this will never pay for itself — belt or cabinet drying costs a fraction per kg. Also skip it if you cannot guarantee no metal enters the chamber: a foil fragment in a microwave field is an incident, not a defect.

Key specifications

Parameter Value
Batch capacity 50-1000 kg/batch by model (TYPICAL, confirm with factory)
Microwave frequency 2450 MHz (TYPICAL)
Installed microwave power 6-60 kW by model (TYPICAL)
Chamber vacuum Typically below 0.09 MPa absolute (TYPICAL)
Product temperature Low, held by vacuum boiling point (TYPICAL)
Contact material SUS304 (EN 1.4301)
Power supply 380V/3P/50Hz or 415V/3P/50Hz, customizable

Specification values are industry-typical ranges for this machine class and are not verified against a specific factory datasheet. Replace them with measured factory data before publication.

FAQ

Why microwave rather than hot air?

Because the energy is absorbed throughout the piece and the water boils at a low temperature. That gives fast drying without the hot surface that causes browning and case hardening.

Does it damage the product?

Less than hot air at equivalent speed, in most cases. The risk is uneven heating from poor penetration or from uneven loading, which shows up as hot spots rather than as general damage.

Can I dry anything in it?

Almost anything that can be loaded, but economics differ sharply. Microwave vacuum drying suits high-value, heat-sensitive product; commodity drying does not justify the capital.

Related equipment

This unit is one stage of a complete processing line. For the full range of drying and dehydration equipment, or to compare this model against the Vacuum Freeze Dryer 200 kg/batch, see the complete equipment catalogue. Capacity, material grade and utility requirements can be confirmed through a quote request.

material

SUS304 (EN 1.4301)

power

380V/3P/50Hz, Customizable

certification

CE+DoC (EU 2023/1230 ready)

surface_finish

Ra≤0.8 μm (food-grade)

application

Berries, General Produce, Root Vegetables

capacity

0.5–1 t/h

automation

Fully Automatic

heating_source

Electric

Reviews

There are no reviews yet.

Be the first to review “Microwave Vacuum Dryer 300 kg/batch”

Your email address will not be published. Required fields are marked *